Standard pumps

For Bosch machines, the most recurrent diameters are : 

• 0.3ml - 1.5ml 
• 1.0ml - 5.0ml 
• 2.0ml - 13.0ml
• 5.0ml - 25.0ml

 Volumes are standard but pieces can be entirely customized according to your dosage problematics.

 All our references are not listed above, we have already made pumps for volumes ranging from 0.120mL until 250mL.

We can, by using our internal design department, adapt a pump design to a new volume range and a particular product.

SPC entire force is this customization of your pump to get the best volume ratio, rate, possible product.

It may be that sometimes it is not enough and that we must act on the dosage pump environment. We are specialized in this sector via trainings and/ or technical expertises.

Our experts come to your lines and guide you until changes can be effective.

We have for example control tools which check the alignment of your pump when it's assemble on the machine to avoid any premature jamming at the start of the production.

- A précision +/- 0.5%*

- A one-piece design of connections

- Surface states validated by manufacturing processes

- A piece design adaptable to your filling pressures

- An advanced expertise for over 50 years

- Volumes ranging from 0.01ml to 100ml

- A design adapted to the requirements of FDA and GMP

- A precision recongnized on volumes < to 0.1ml

*According to filling conditions consistent with SPC recommendations

-  Piston conception with a flat or groove of distribution

- Long guidance ( piston and/or bushel )

- Special geometry for cristallising products

- SPC Kit of pump two pieces adaptation on Bosch machine

- IC Control ( alignment control tool ) for pump 3 pieces

- Custom game with realisation of products tests according to your production conditions

- Other on demand